Application...

Below you will see a step by step I prepared on how to apply the piece.

Step by Step of applying the demonic nightmare prosthetic.

Step one: Tell the model to place the contact lenses in there eyes, if they want the make up artist can place them in.

Step two: Clean models face with a small amount of toner.

Step three: Using a cotton bud and some pros-aid apply the prosthetic piece working from the centre outwards. Apply the pros-aid over where the nose is in the prosthetic piece and also across the centre of the forehead are. Repeat this process on the places on the models face this will anchor the piece to the face. Place the piece on the face whilst the glue is still wet this give you the chance to move it into place. Once the pros-aid drys it will not move about.

Step four: Work your way outwards repeating the same process as above, for example after the centre of the face, apply pros-aid to the upper lip area followed by the chin leaving the edge. As said before continue to repeat the process working your way out.

Step five: Once all is secure, start sticking the edges down take your time, you could use a clean cotton bud and roll it over the edges in an outwards motion. Do this with all edges including the eyes.

Step six: Powder the eye lids, to ensure they don't get stuck open. This step is important for that reason.

Step seven: Check the prosthetic piece is secure, ask the model to make some facial expressions such as; frowning etc.

 

Here are some images of the applied piece from different angles.